part of

Project A-spec

 

  MODZ
 
    Welcome to the tips and modz, here there is information about how to do mods and and stuff like that. Every time I do something to my car I will take pictures and show how I did it. In other words its a tutorial as soon as I get some modz done to my car. I have a K & N air filter but thats about it. I figure that if you can't even put an air filter in your car you deserved to be knocked up-side the head. Then again not averyone know what a screwdriver is, and no uncle Mark I'm not talking about a drink.

K & N Air Filter

  1. Remove the hose running from the throttle body to the air box. it will be hard to get to the box unless you do. if you can't remove it completely don't worry just move a little.
  2. Move the air box so you can get at it and unclip the metal clips holding the box together.
  3. Take off the top, I know its hard there is a lot in the way, and take out the stock air filter. Now put the new one in.
  4. Clip the top back into the air box and move it back into place.
  5. Hook the air hose back to the throttle body and air box.
  6. Put the little sticker that says that this car is equipped withan K & N air filter. Its shaped like a stop sign.

Rewired Fog lights

Ok here is the deal, we all know that a neon equipted with the OEM fog light turn off when you turn on your headlights. This little Mod keeps them on all the time and the turn off when you turn off your car or when you flip the switch.

  1. Pull out the fog light/rear defogger panel by prying at the bottom with a flat headed screwdriver.
  2. Cut the violet with white tracer wire, leave as much wire free at the base of the fog light switch.
  3. Tape and tie the free end of the violet with electrical tape, You don't want it shorting out on something.
  4. Strip the free end of the violet with white wire that's still connected to the fog light switch connector.
  5. Strip a small section of the white wire that comes from the rear defog switch. DO NOT cut this wire, strip a section to make a splice. This is the third wire from the top.
  6. Connect the stripped end of the violet with white wire to the white wire. Wrap tightly and solder. Tape and tie to prevent shorts.
Back to Neon Elite